Iconen_Geo-matching_zondertekst5

 

 

Land Surveying and Cadastre                           

Inertial Navigation Systems - Bridging the Positioning Gap


Inertial Navigation Systems (INSs) are a great help in applications where either position stability is of great importance or where bridging (small) positioning gaps is a requirement. To understand INS, imagine you are standing blindfolded in the centre of a long hallway. Then you start walking. You may proceed quickly at first, compensating as needed and covering ground with confidence. Eventually, however, you begin to lose your sense of alignment. This ability to successfully navigate when denied a visual frame of reference, even for a relatively short amount of time, represents our own basic human form of inertial navigation.

 

 By Huibert-Jan Lekkerkerk, contributing editor, Hydro International.

 

 

How does an inertial navigation system work?

 

An INS is a relative positioning system. That is, it computes a position difference from a starting position (the centre of the hallway) using information about distance and direction. The combination of a 3 dimensional direction and a 3 dimensional acceleration / speed translates into a 3 dimensional position difference when computed over time. The direction and acceleration are determined from an Inertial Measurement Unit (IMU). A modern IMU is of the ‘strap down’ type and built around 3 accelerometers and three gyroscopes to provide rotation information. By using the 6 sensors from the IMU and combining them with the position information from, for example, a GNSS or a USBL system, a new position can be computed allowing the IMU to bridge a (small) gap in positioning information. This time, while travelling the same hallway blindfolded, a friend verbally directs you once per second. This greatly increases chances that you will proceed faster, never touch a wall, and will stop safely at the end.

 

 Eclipse

 

How to use an inertial navigation system?

 

An INS can achieve very high accuracies where heading, roll, pitch, heave and position information is concerned. The quoted accuracies are, however, those of the INS itself and are only achieved when the system has been properly set up. This requires knowledge of the various integration parameters according to the type of platform and its most probable behaviour (filter settings).

But even with the proper settings an INS only provides a reliable position if it is properly aligned to the platform on which it is installed. This means that the axis of the INS must be exactly aligned with the axis of the platform (vessel geometry). This is done by aligning the sensor as well as possible in a mechanical sense and then determining the remaining offset using a proper calibration procedure.

When separate positioning sensors are used such as GNSS or a separate USBL, the relative position of the positioning sensor to the IMU must be determined accurately to achieve the advertised accuracy of the INS. To achieve this, an integrated unit with for example USBL + IMU may prove helpful as the offsets have already been modelled into the unit by the manufacturer requiring less set-up by the end-user.

 

APX-15 Inertial Navigation System

Compare inertial navigation systems on Geo-matching.com 

 

on Geo-matching.com you can compare Inertial Navigation Systems from 18 suppliers and view brochures, case studies and product videos. Click here to visit the INS category. 

  

Inertial Navigation Systems

 

 

Read the full article on Hydro International!